Laminating machine vacuum film coating is the use of special membrane between the drawing and vacuum vacuum laminating machine in a certain temperature after finalize the design, complete coated. Its operating method is complex, high cost and screen size by certain limitations, but worked on high quality, strong image texture, suitable for photos.

Laminating machine vacuum laminating troubleshooting a: don't start the machine

Input wire, power cords, voltage is not enough.

Laminating machine vacuum laminating troubleshooting 2: temperature measurement is not accurate

Thermocouple, temperature controller. If installation is not correct, and the damage.

Laminating machine vacuum laminating troubleshooting 3: work on vacuum degree

Gas circuit impassability, hand valve or electromagnetic valve is not closed, vacuum pump motor belt is loose, damage of vacuum gauge.

Laminating machine vacuum laminating troubleshooting four total power switch, trip

Heating box input wire leakage, leakage, distribution box outside the wire on the device, electric leakage, etc.

Laminating machine vacuum laminating troubleshooting 5: membrane absorption does not reach the designated position

Vacuum degree is insufficient, leakage, temperature is not enough, the membrane is too thin, posted on other material of workpiece, workpiece concave depth over the lift of membrane, suction time too short, membrane no pushovers, workpiece is too close.

Laminating machine vacuum laminating troubleshooting 6: cover the surface of workpiece is broken and can not smooth or Angle

Film is not straight, the film quality is bad, the workpiece polishing is not good, glue injection of too many, artifacts below the touch panel is too low.

Laminating machine vacuum laminating troubleshooting 7: not to be when the membrane absorption down

The solenoid valve or hand valve is open.

Laminating machine vacuum laminating troubleshooting eight: play break phenomenon

Temperature is too high, heating time is too long, the film quality is bad, no heating.